Industrial Band Saw Safety

• Contact with the moving blade at the cutting point
• Hands pulled toward the blade by shifting or binding stock
• Blade breakage, derailment, or damaged wheels and guides
• Long, round, or heavy stock rolling, dropping, or shifting
• Sharp chips, burrs, and cut material causing injuries
• Adjusting guides, clearing chips, or retrieving parts while the saw is moving

Industrial band saws use a continuous moving blade that can cut quickly and may remain in motion after the stop control is used. Both vertical and horizontal saws require stable workholding and guarded blade exposure.

The blade, wheels, guides, guards, vise, feed system, and controls should be inspected before use. A cracked, dull, damaged, improperly tensioned, or incorrect blade can bind, wander, break, or leave the wheels.

Adjustable blade guards and guides should be positioned close to the work while allowing the cut. Excessive exposed blade increases the area where accidental contact can occur.

Stock should be clamped or supported so it cannot spin, roll, lift, or drop. Long, round, bundled, irregular, or heavy material may require rollers, stands, fixtures, or lifting equipment.

Hands should stay out of the cutting path and should not be used to hold small pieces near the blade. Push tools, fixtures, vises, or another approved method should be used when the work cannot be controlled safely.

Feed pressure and blade speed should match the material and cut. Forcing the stock, twisting it, or changing direction while the blade is engaged can cause binding, breakage, or sudden movement.

Chips, short cutoffs, and scrap should be removed only after the blade stops or by an approved tool that keeps hands away. Workers should also account for hot or sharp cut surfaces.

The saw should be stopped when the blade tracks poorly, unusual vibration develops, stock shifts, coolant flow fails, or a guard, guide, vise, or control is damaged.

• Inspect blade condition, tracking, tension, guides, and guards.
• Set blade guards close to the work.
• Clamp and support stock against rolling or dropping.
• Keep hands and body parts out of the blade path.
• Use the proper speed and controlled feed pressure.
• Wait for complete blade stoppage before adjustment or cleanup.
• Remove the saw from service when tracking or controls are unreliable.

• Is the blade correct, serviceable, and properly tensioned?
• How is the stock secured and supported?
• How much blade is exposed above or around the work?
• Could the material roll, pinch, drop, or bind during the cut?
• How will cutoffs and chips be removed safely?